Medical PETG


Pacur® PETG Medical Grade CD (Clear Denest) is extruded from copolyester resin. Engineered as an alternative to silicone coating, PETG CD promotes consistency and ease in denestability while minimizing haze. It is an exceptionally clear and tough material making it ideally suited for use as a blister package  material. It is FDA approved for use in medical device, pharmaceutical, and food packaging applications. It will withstand ethylene oxide, electron beam and gamma ray sterilization. Other end uses include general purpose blisters, skin packaging, graphic arts, and stationary. Silicone coating is available upon customer request.


  • Exceptionally Clear
  • Chemical Resistant
  • Improved Notch and Puncture Resistance
  • BPA and Chlorine Free
  • Highly Recyclable
  • Exceptional Toughness
  • Great Impact Resistance
  • Easy Thermoforming, Cutting, Trimming, and Printing


  • Near Optical Clarity
  • Reduced Packaging Cost
  • No Stress Whitening
  • No Pre-Treatment for Printing
  • Fast Cycle Times
  • Minimal Trim Dust
  • Less Breakage

Sterilization Methods

  • Ethylene Oxide
  • Gamma
  • Electron Beam

46 Replies to “Medical PETG”

  1. Photo Liker, Status Liker, Working Auto Liker, Auto Like, Photo Auto Liker, Autoliker, autolike, auto like, Auto Liker, Autolike, Autoliker, Autolike International, Increase Likes, ZFN Liker, Status Auto Liker, auto liker, autoliker

  2. Hey there! This is kind of off topic but I need some help from an established blog. Is it difficult to set up your own blog? I’m not very techincal but I can figure things out pretty quick. I’m thinking about setting up my own but I’m not sure where to start. Do you have any points or suggestions? Thank you

  3. I have not checked in here for a while because I thought it was getting boring, but the last several posts are great quality so I guess I will add you back to my daily bloglist. You deserve it my friend 🙂

Leave a Reply

Your email address will not be published.